To have one mobo fan header control the speeds of the fans, you must connect the proper cable to that header. These choices are made using switch settings in that software. Then you have the choices to have that Hub's software utility control the fan speeds AND the fan LIGHTS, OR to turn over either or both of those controls to signals from MOBO headers. The Lian Li web page for these fans points out that they must be used with their Uni Hub. When a Hub is involved the speeds of the "other" fans cannot be monitored, so from time to time YOU should check that all the fans still are working.Ģ. The second function of a fan header is to monitor the speed signal for fan FAILURE (i.e., so speed signal) and put out a warning if that happens. However, this does have an impact on another item. And if all the fans are the same (as yours are), you just presume they all are doing the same thing. This does NOT affect ability to control speeds. So, when you use a Hub, that Hub will send back to the host header the speed of ONE of its fans and ignore all the rest. FYI, any mobo fan header can accept the speed signal sent back to it from only ONE fan.
0 kommentar(er)
